SC4-CONCERTO

DOWNLOAD DATASHEET

SC4-CONCERTO

CompactPCI® Serial CPU Card

Intel® XEON® E3 v5 Mobile Workstation Processor

or 6th Generation Intel® Core™ Processor

The SC4-CONCERTO is a rich featured high performance 4HP/3U CompactPCI® Serial CPU board, equipped with an Intel® Xeon® E3 familiy mobile workstation processor (Skylake Halo platform) for demanding applications. For scalability, the SC4-CONCERTO is also available with a 6th Generation Intel® Core™ Skylake processor.

The SC4-CONCERTO front panel is provided with two Gigabit Ethernet jacks, two USB 3.0 receptacles, and two DisplayPort connectors. In addition, up to two USB Type-C front panel receptacles are available as an option, one of them usable alternatively as (third) DisplayPort.

On-board mass-storage solutions are based on a low profile mezzanine expansion card, which accommodates two M.2 style SSD modules. One of the M.2 sockets is suitable for a fast NVMe (PCIe Gen3 x 4) module, and the other for a low cost SATA type M.2 SSD

The SC4-CONCERTO is equipped with up to 32GB DDR4 RAM with ECC support. Up to 16GB memory-down are provided for rugged applications, and another 16GB are available via the DDR4 ECC SO-DIMM socket.

The powerful Xeon® E3-1500 v5 series processor is accompanied by the CM238 mobile PCH, for a maximum of high speed I/O resources (e.g. PCI Express®, SATA, USB). Thus, 22 PCIe lanes are available for backplane use, and up to 8 lanes for local mezzanine expansion.

The SC4-CONCERTO is provided with an on-board SATA hardware RAID controller, enabling high-capacity mass storage solutions across the CompactPCI® Serial backplane.

As an option, up to eight Gigabit Ethernet Ports are available via the backplane connector P6 (low profile mezzanine expansion card).

The SC4-CONCERTO is equipped with a set of high-speed local expansion interface connectors, which can be optionally used to attach either a low profile mezzanine module (fits into the 4HP front panel envelope) or a side board for an 8HP or even 12HP assembly in total.

The connectors HSE1 and HSE2 are high speed connectors, as required for PCI Express® Gen3 and SATA 6G. The socket EXP is used as a legacy interface (e.g. HD Audio, LPC) and not required for many mezzanine modules. All connectors allow board-to-board heights of 9.5mm (C4* series, S20, S40), 10.8mm (S60, S80), and 18.7mm (SC* side cards 8HP assembly).

HSE1 can be configured for either 4 x PCIe or 4 x SATA, or 2 x PCIe and 2 x SATA, thanks to the flexible HSIO channels of the CM238 PCH. When HSE1 has been setup for SATA, the SC4-CONCERTO can be combined e.g. with low cost SSD mass storage mezzanine modules such as the C47-MSATA (dual mSATA carrier) or C48-M2 (dual M.2 SATA sockets). For high performance NVMe based SSD mezzanine modules (S20/40/60) HSE1 must be configured as PCIe x 4.

HSE2 is assigned to 4 x PCIe, and in addition the 3rd DisplayPort video output. While S20 and S60 get along with HSE1 only, the S40 and S80 mezzanine modules depend on both HSE1 and HSE2, for additional I/O. Please refer also to Mezzanine Conectors.